Grease traps are designed to trap grease, as the name suggests. They function by trapping oil from water but oftentimes, we see grease as the main problem in traps. They easily solidify from the trap itself and cause major burden for home and business owners alike. However, if the system is well maintained or regularly maintained, they can work excellently in keeping the trap clean. This is how this works, the substances will pass through a catching system, this will give them time to cool off and solidify then the water will pass through the drain normally. As simple as that, yes but why are there problems that occur? It is because of the quality of maintenance being done as well as the way how it is maintained. When you do what is right, you will eventually be able to save a lot just by following these simple steps to Grease Trap Maintenance NYC.
First is to remove the trap gently
using a pry bar. You have to do this slowly and gently as there are small parts
such as gaskets for the trap situated under the cover. Damaging these small
parts will mean another expense for the replacement.
The second
step is to check or inspect the part when the lid is separated. In this step,
during the cleaning, you will be replacing and removing
parts during cleaning and it is important that you need to know where these all
are located in order for you to be able to put them back properly. It is
advised that you follow the manual or have the manual ready in case you forget
how to put everything back together.
You may also
want to insert a wooden dowel or measuring stick into the grease trap. You will use this to
measure how much oil is in your drain and you will know when the right time is
to clean and do maintenance of your trap.
For the next
move, you will need to remove the waste from your trap with the small bucket. All you need is to
use the bucket to bring out the solidified waste.
6
Clean the lid
as well as the sides of the trap with your bucket. Be sure to take out
the pieces of fat or oils that are attached to the trap. You can even clean the
trap well with the use of wet or dry vacuum to suck out any smaller pieces of
waste that are stubborn or difficult to remove.
You
will then Clean the lids, trap sides,
and parts with room-temperature water and soap. You may make use of steel
pot scrubber to remove excess waste and unwanted odor. Flush the trap and sides
with water.
After
doing all these steps, it is now time to re-install the grease traps parts by following your manual or diagram. Next
is to Replace the lid when all the parts are working and secured.
Take
note that if the above guide is did help not solve your problem, a Grease Trap Maintenance NYC service should be your other option.